Heath Zenith 9600LED series Testing and Adjustments, Turn on the circuit breaker and light switch

Testing and Adjustments

1.Turn on the circuit breaker and light switch.

Note: Sensor has a 1 1/2 minute warm up period before it will detect motion. When first turned on wait 1 1/2 minutes.

2.Set:

ON-TIME switch to TEST SENSITIVITY dial to Midway

	180°
6 ft.
(1.8 m)
	30 ft.
	(9.1 m)
Maximum Range	Maximum
	Coverage Angle*
	(Top View)

–

TEST 5 10 DUSK MINUTES TO DAWN

Photocell

+

SEN

The sensor is less sensitive to motion directly towards it and more sensitive to motion across coverage area.

MotionMotion

3.Walk through the coverage area noting where you are when the lights turn on. In TEST mode, light will stay on for 5 seconds after sensing motion and then turn off.

4.Adjust the SENSITIVITY to increase or decrease the range as needed. Too much sensitivity may cause false triggering due to heat sources in the coverage area (see Adjustment of Coverage Area or Troubleshooting section).

5.Set the amount of ON-TIME you want the light to stay on after motion is detected (5 or 10 minutes) or...

Set the ON-TIME to the DUSK-to-DAWN setting if you want the light to stay on all night, every night. The photocell will turn the light off during the day.

	Sensor
Least Sensitive	Most Sensitive

598-1338-03 5