SECTION
Firm/Soft Buttons
1.Select comfort pressure settings by pressing Firm ( 
) or Soft (
) button.
•Soft Button - Pressing this button reduces the pressure setting in the mattress.
•Firm Button - Pressing this button increase the pressure setting in the mattress.
NOTE: The patient comfort pressure ranges from Soft (level 0 = 6±4 mmHg) to Firm (level 9 = 32±6 mmHg). The Comfort Control LED displays the patient comfort pressure levels from 0 to 9 and provides a guide to the caregiver to set approximate comfort pressure level depending on the patient weight. If the patient’s weight to height ratio is above average, increase the pressure setting by approximately 20%.
Fowler Button
Manual Mode
1. Press the Fowler button (
) to activate the patient fowler mode.
NOTE: The Fowler LED illuminates when in this mode. When this mode is activated, the control unit increases the pressure in the mattress to prevent the patient from bottoming out.
Automatic Wireless Mode
When the bed articulates to 45°, the transmitter in the head of the mattress signals the control unit to increase the pressure in the mattress by 80% to prevent the patient from bottoming out.
Fowler Transmitter Setup
1.Make sure the bed is in the flat position.
2.Make sure fowler transmitter is in the mattress cover pocket in the orientation indicated on the transmitter.
NOTE: The mattress cover pocket is on the inside of the lower mattress cover on the left side of the head end of the mattress.
3.Perform one of the following:
•MA60 - Press and hold the Max Inflate and Fowler buttons.
•MA65 - Press and hold the Mode and Fowler buttons.
NOTE: The Fowler LED is lit and L displays in the LCD Display.
4. Raise the bed to 45°.
NOTE: The control unit will beep and will return to Standby.
5.Perform one of the following:
•Cancel - Press the Fowler button to exit Fowler Transmitter Setup without linking to a transmitter.
•Save - Wait 60 seconds without pressing a key.
MA60 Series | 16 | Part No 1148137 |