Invacare MA60, MA65 Powering Up the System, Placing the Patient on the Mattress, Power Fail LED

Page 18

SECTION 2—OPERATION

Alarm Silence mode - Pressing this button silences the alarm that sounds in the event of power failure or when the hose is disconnected from the control unit.

NOTE: The Alarm LED illuminates when in this mode.

Power Fail LED

In the event of power outage, an alarm sounds and Power Fail LED flashes AMBER. The control unit has internal memory and retains the previous settings during the power outage.

NOTE: During a power outage, the mattress retains the air as long as the mattress is connected to the control unit.

Low Pressure LED

In the event that the mattress hose disconnects, an alarm sounds and Low Pressure LED flashes AMBER. Once the low pressure problem is fixed, the control unit resumes operation in the previously set mode.

Powering Up the System

NOTE: For this procedure, refer to FIGURE 2.3 on page 14.

1. Turn on the power to the system by pressing the Power button on the control unit.

NOTE: Once the button is released, a GREEN LED illuminates when the unit is on.

Placing the Patient on the Mattress

1. Press the Max Inflate button to turn on the control unit to maximum flow.

NOTE: In this mode, the Max Inflate LED lights up.

2.Place the patient on the mattress.

3.Ensure that the patient’s feet are towards the foot end of the mattress (the end with the hose).

4.Center the patient on the bed from side-to-side and head-to-foot.

NOTE: Special positioning may be required with contracted patients to provide comfortable positions.

5.After placing the patient, make certain no objects will fall under the patient, such as feeding tubes, IV's etc.

6.Wait five minutes for the mattress pressure to stabilize.

7.Once the mattress inflates to its normal size, set the comfort pressure to the desired comfort level.

8.Wait five minutes for the mattress pressure to stabilize.

MA60 Series

18

Part No 1148137

Image 18
Contents MA60 Series Dealer This manual Must be given to the user of the productSpecial Notes Special NotesTable of Contents Register Online at warranty.invacare.com Register Your ProductPerformance Parameters Typical Product ParametersElectrical Parameters Mechanical ParametersEnvironmental Parameters Label Location Contraindications Safety InstructionsGeneral Guidelines Entrapment May OccurSmoking Fire HazardElectrical Anesthesia EquipmentInstalling the Powered Mattress OperationInstalling the Side Rails Installing the Control Unit Installing the Powered MattressConnecting the Hose Connecting the HoseConnecting the Power Cord Using the Front Panel Power ButtonAlternating Pressure Button Static ButtonFirm/Soft Buttons Fowler ButtonLock/Alarm Silence Button Max Inflate/Low Air Loss ButtonPlacing the Patient on the Mattress Powering Up the SystemPower Fail LED Low Pressure LEDTransferring Patient From/To a Gurney Preparing for CPR Procedure About Power Outage and TransportationTransferring Patient From/To a Wheelchair Maintenance and Troubleshooting Cleaning the SystemStoring the System Troubleshooting Problem Cause SolutionLimited Warranty USA
Related manuals
Manual 2 pages 10.7 Kb