Pacific Cycle HF3305 manual Lubrication and Adjustment Cotterless Cranks, To disassemble

Fixed Cup

Bottom Bracket

Cotterless Crank removing tool

Lubrication and Adjustment

- Cotterless Cranks

To adjust the free play in a three piece type bottom bracket, loosen the lockring on the left side by turning it counter-clockwise, then turn the adjusting cup as required. Re-tighten the lockring taking care not to alter the cup adjustment.

To disassemble:

85

	Ball Retainer
	Adjusting Cup
Bottom Bracket	Lockring
Shell
Axle
	Remove the dust cap.
	Loosen and remove
	the flange nut.

1.Remove the cranks from the axle.

2.Remove the left side lockring by turning it counter-clockwise.

3.Remove the adjusting cup by turning it counter-clockwise.

4.Remove the left ball retainer and slide the axle out of the frame to the left.

5.Remove the right side fixed cup by turning it counter-clockwise and remove the right ball retainer. Clean and inspect all bearing surfaces

and ball retainers, and replace any damaged parts. Pack the ball bearing retainers with grease, then re-assemble in reverse of the above procedure.

Cotterless Crank Removal

To remove cotterless cranks use the following procedure. Note that a special tool will be required.

1.Remove the dust cap with a coin or screwdriver.

2.Loosen the flange nut or bolt and washer, and remove.