Assembly
5.Feed the console wire coming out of the console through the tube of the right han- dlebar. Connect the EKG harness and the toggle harness coming from the handlebar to the EKG harness and the toggle harness coming from the console.
Secure the left and right handlebars to con- sole using two bolts M8x50 and two wash- ers M8 per side.
NOTE: Make sure not to pinch any wires when securing the left handlebar.
Bolt M8x50 | Toggle | |
Harness | ||
| ||
Washer M8 | ||
| Console Harness | |
EKG |
| |
Harness | ||
Left Handlebar | Toggle | |
Harness | ||
| ||
| EKG | |
| Harness | |
| Right Handlebar | |
Figure 5: Console Assembly
6.Connect the console harness together. One side of harness is coming from the right upright. The other end is coming from the console.
Attach the console onto the uprights by sliding into the uprights.
NOTE: Make sure that the console har- ness is inside of the upright and not being pinched.
Secure the console to the uprights using two bolts M10x25 and two washers M10 per side.
IMPORTANT PLEASE NOTE:
Tighten all hardware installed in Step 2 through Step 6.
Console |
Washer M10 |
Console |
Harness |
Bolt M10x25 |