NordicTrack NTTL90080 manual Maintenance and Trouble-shooting, Symptom the Power does not Turn on

Page 15

Maintenance and Trouble-shooting

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed.

If further assistance is needed, please contact our Customer Service Department.

1. SYMPTOM: THE POWER DOES NOT TURN ON

a. Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into

a properly grounded outlet. (See How to Plug in the Power Cordon page 7.) Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length. If using a surge protector with

a power switch, make sure that the power switch is in the “on” position.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console. (See step 2 on page 9.)

c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

d. Check the on/off switch located at the front of the treadmill near the power cord. The switch must be in the “on” position.

c

 

Tripped

Reset

d

 

“On”

 

Position

 

2.SYMPTOM: THE POWER TURNS OFF DURING USE

a.Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Check to make sure that the on/off switch is in the “on” position. (See 1. d. above.)

c.Make sure that the power cord is plugged in.

d.Remove the key from the console. Reinsert the key fully into the console. (See step 2 on page 9.)

e.If the treadmill still will not run, please call our Customer Service Department.

3.SYMPTOM: AN ERROR CODE (“E1” OR “E6”) APPEARS ON THE CONSOLE

a. If the console detects an incline error, an

“E6” may appear in the INCLINE/DISTANCE display when the

 

 

INCLINE buttons are pressed, and when the display shows the current incline level. If this error code

 

 

appears, remove the key from the console, wait for ten seconds, and then reinsert the key. If the error code

 

 

appears again, call our Customer Service Department.

Do not operate the treadmill until the problem is

 

corrected.

 

 

 

b. If the console detects a speed error (no speed signal, an erratic speed signal, etc.), an

“E1”

may appear in

the SPEED display. If this error codes appears, remove the key from the console, wait for ten seconds, and

 

 

then reinsert the key. If the error code appears again, call our Customer Service Department.

 

Do not oper-

ate the treadmill until the problem is corrected.

 

 

 

15

Image 15
Contents Customer Information Table of Contents Never insert any object into any opening Important PrecautionsNever move the walking belt while the power Never leave the treadmill unattended while itDecal in the location shown Before You Begin Wrench Clip AssemblyTreadmill Operation Refer to miles Diagram of the ConsoleFeatures of the Console Clip KeyHOW to USE the Manual Mode TIME/PACE display Follow your progress with the four displaysPULSE/CALORIES display Optional CardioTrack heart rate monitor+ button to start the program HOW to USE the Incline ProgramsInsert the key fully into the console Select one of the Incline programsThousands digits will be shown in the Speed display HOW to Select the Information ModeHOW to Move the Treadmill HOW to Fold the Treadmill for StorageHold the treadmill firmly with both hands, and lower HOW to Lower the Treadmill for USESymptom AN Error Code E1 or E6 Appears on the Console Maintenance and Trouble-shootingSymptom the Power does not Turn on Symptom the Power Turns OFF During USEUnplug the Power Cord Symptom the Walking Belt Slows When Walked onEdges From the hood. Carefully remove the hood Magnet and the Reed SwitchAny exercise program Conditioning GuidelinesFactors in a Sensible Diet Exercise StepsHamstring Stretch Weight Loss TipsWarm up before you begin Toe Touch StretchParticipate in strength training Get FIT with the PowerTreadBenefits of Aerobic Exercise SessionWorkout Tips Workout ProgramsHeart Rate Intensity Pad Screw To find the parts listed below, refer toAttached in the center of this owner’s guide Description Key No. QtyBlack Wire, 2 Female Blue Wire, 2 FemaleDescription Call us Write us How to Order Replacement PartsManufacturer’s 90-Day Limited Warranty Service@nordictrack.comExploded Drawing-Model No. NTTL90080 To identify the parts shown on thisRefer to the Part List on page 22 of the owner’s guide Rev a