NordicTrack NTTL90080 Unplug the Power Cord, Symptom the Walking Belt Slows When Walked on, Edges

Page 16

4. SYMPTOM: THE WALKING BELT IS OFF-CENTER WHEN WALKED ON

a.

If the walking belt has shifted to the left

, first remove the key

 

and

UNPLUG THE POWER CORD

. Using the included allen

 

wrench, turn the left rear roller adjustment bolt clockwise, and

 

the right bolt counterclockwise, 1/4 of a turn each. Be careful not

 

to overtighten the walking belt. Plug in the power cord, insert the

 

key and run the treadmill for a few minutes. Repeat until the

 

walking belt is centered.

 

b.

If the walking belt has shifted to the right

, first remove the

 

key and

UNPLUG THE POWER CORD

. Using the allen wrench,

 

turn the left rear roller adjustment bolt counterclockwise, and the

 

right bolt clockwise, 1/4 of a turn each. Be careful not to over-

 

tighten the walking belt. Plug in the power cord, insert the key

 

and run the treadmill for a few minutes. Repeat until the walking

 

belt is centered.

 

c.

If the walking belt slips when walked on

, first remove the key

 

and

UNPLUG THE POWER CORD

. Using the allen wrench, turn

 

both rear roller adjustment bolts clockwise, 1/4 of a turn. When

 

the walking belt is correctly tightened, you should be able to lift

 

the edges

of the walking belt 3 to 4 inches off the walking plat-

form. Be careful to keep the walking belt centered. Plug in the power cord, insert the key and run the treadmill for a few min- utes. Repeat until the walking belt is properly tightened.

a

b

c

5.SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON

a. Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.

b. If the walking belt is overtightened, treadmill performance may

 

decrease and the walking belt may be permanently damaged.

 

Remove the key and

UNPLUG THE POWER CORD

. Using the

allen wrench, turn both rear roller adjustment bolts counterclock-

 

wise, 1/4 of a turn. When the walking belt is correctly tightened,

 

you should be able to lift

the edges

of the walking belt 3 to 4

inches off the walking platform. Be careful to keep the walking belt centered. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is prop- erly tightened.

b

3–4”

Rear Roller Adjustment Bolts

c. If the walking belt still slows when walked on, please contact our Customer Service Department.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Customer Information Table of Contents Important Precautions Never move the walking belt while the powerNever leave the treadmill unattended while it Never insert any object into any openingDecal in the location shown Before You Begin Assembly Wrench ClipTreadmill Operation Diagram of the Console Features of the ConsoleClip Key Refer to milesHOW to USE the Manual Mode Follow your progress with the four displays PULSE/CALORIES displayOptional CardioTrack heart rate monitor TIME/PACE displayHOW to USE the Incline Programs Insert the key fully into the consoleSelect one of the Incline programs + button to start the programHOW to Select the Information Mode Thousands digits will be shown in the Speed displayHOW to Fold the Treadmill for Storage HOW to Move the TreadmillHOW to Lower the Treadmill for USE Hold the treadmill firmly with both hands, and lowerMaintenance and Trouble-shooting Symptom the Power does not Turn onSymptom the Power Turns OFF During USE Symptom AN Error Code E1 or E6 Appears on the ConsoleSymptom the Walking Belt Slows When Walked on Unplug the Power CordEdges Magnet and the Reed Switch From the hood. Carefully remove the hoodConditioning Guidelines Factors in a Sensible DietExercise Steps Any exercise programWeight Loss Tips Warm up before you beginToe Touch Stretch Hamstring StretchGet FIT with the PowerTread Benefits of Aerobic ExerciseSession Participate in strength trainingWorkout Programs Workout TipsHeart Rate Intensity To find the parts listed below, refer to Attached in the center of this owner’s guideDescription Key No. Qty Pad ScrewBlue Wire, 2 Female Black Wire, 2 FemaleDescription How to Order Replacement Parts Manufacturer’s 90-Day Limited WarrantyService@nordictrack.com Call us Write usTo identify the parts shown on this Exploded Drawing-Model No. NTTL90080Refer to the Part List on page 22 of the owner’s guide Rev a
Top Page Image Contents