NordicTrack NTL12840 user manual Assembly

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench and your own phillips screwdriver and

wire cutters . For help identifying the assembly hardware, see the hardware drawings below.

4 1/2” Bolt (78)–4

Handrail Spacer

(77)–4

4” Bolt (53)–2

			Handrail Washer
3” Bolt (125)–2	1” Tek Screw (47)–4		(124)–2
1. With the help of a second person, carefully raise the	1
Uprights (69) to the position shown.
See the inset drawing. Insert one of the Extension Legs
(102) into the treadmill as shown. Make sure that the		69
Extension Leg is turned so the Base Pad (99) is be-
neath it. Note: It may be helpful to tip the Uprights (69)
forward as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same			69
way.
			102
			99
2. Press the Latch Knob Sleeve (70) into the left Upright (69).	2
			69
Remove the Latch Knob (68) from the Latch Pin (74).	68	35
Make sure that the Latch Pin Collar (72) and the Spring
(71) are on the Latch Pin. Insert the Latch Pin into the			70
Latch Knob Sleeve (70) and the left Upright (69). Press
the Latch Knob Spacer (35) onto the other side of the left			71
			72
Upright, and then tighten the Latch Knob back onto the
Latch Pin.			74

6