HOW TO USE A PROGRAM DIRECTLY FROM OUR WEB SITE
To use programs from our Web site, the incline trainer must be connected to your home computer. See HOW TO CONNECT YOUR COMPUTER on page 23. In addition, you must have an internet connection and an internet service provider. A list of specific system requirements is found on our Web site.
Follow the steps below to use a program from our Web site.
1 Insert the key into the console.
See HOW TO TURN ON THE POWER on page 13.
2 Select the iFIT.com mode.
To use an iFIT.com program from our Web site, first press the iFIT.com but- ton. The iFIT.com indicator will light.
Go to your computer and start an internet
3 connection.
Start your web browser, if necessary, and go to
4 our Web site at www.iFIT.com.
Follow the desired links on our Web site to se-
5 lect a program.
Read and follow the
Follow the on-line instructions to start the
6 program.
When you start the program, an
Return to the incline trainer and stand on the
7 foot rails. Find the clip attached to the key and slide the clip securely onto the waistband of your clothes.
When the
“chirping” sound will alert you when the speed and/or incline of the incline trainer is about to change. CAUTION: Always listen for the “chirp” and be prepared for speed and/or incline changes.
If the speed or incline settings are too high or too low, you can manually override the settings at any time by pressing the Speed or Incline buttons on the console. However, when the next “chirp” is heard, the speed and/or incline will change to the next settings of the program.
To stop the walking belt at any time, press the Stop button on the console. The time will begin to flash in the Time/Distance display. To restart the walking belt, press the Start button or the Speed + button. After a moment, the walking belt will begin to move at 1 mph. When the next “chirp” is heard, the speed and/or incline will change to the next settings of the program.
When the program ends, the walking belt will stop and the time will begin to flash in the Time/Distance display. Note: To use another program, press the Stop button and go to step 5.
Note: If the speed or incline of the incline trainer does not change when a “chirp” is heard, make sure that the iFIT.com indicator is lit and that the time is not flashing in the Time/Distance display. In addition, make sure that the audio cable is properly connected, that it is fully plugged in, and that it is not wrapped around a power cord.
8 Follow your progress with the displays.
See step 5 on page 14.
9 Measure your heart rate if desired.
See step 6 on page 15.
10 Turn on the fans if desired.
See step 7 on page 15.
11 Use the upper body handles if desired.
See step 8 on page 15.
12 Whenkey. you are finished exercising, remove the
See step 8 on page 17.
26