NordicTrack NTL06907.1 Assembly, Hardware may be included, Do not fully fold the Frame yet

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex keys and your own Phillips screwdriver		and
adjustable wrench	.

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly. Extra

hardware may be included.

1" Tek Screw (2)–4	3/8" Star	1/4" Star	3/8" Nut (8)–4
Base Pad Spacer		Washer (10)–6
	Washer (9)–7
(13)–2

1/4" x 1/2" Bolt (7)–6

3/8" x 1 1/4" Bolt (5)–3

3/8" x 2" Bolt (4)–4

	3/8" x 4 1/2" Bolt (6)–4
1. Make sure that the power cord is unplugged.	1
With the help of a second person, carefully tip		A
		B
the treadmill onto its left side. Partially fold the
		38
Frame (56) so that the treadmill is more stable;		Hole
do not fully fold the Frame yet.
	83	81
Remove and discard the two indicated bolts (A)	56
and the shipping bracket (B).
Cut the tie securing the Upright Wire (38) to the		2
		Tie
Base (83). Locate the tie in the indicated hole in
the Base, and use the tie to pull the Upright Wire
out of the hole.
	13
Attach a Base Pad (81) to the Base (83) in the	81
location shown with a Base Pad Spacer (13) and	2
a 1" Tek Screw (2). Then, attach another Base
Pad (81) with only a 1" Tek Screw (2).
	6