8. Have a second person hold the Bridge (95) near | 8 | |
the Right Upright (78). Remove the wire tie from | ||
95 | ||
the Upright Wire (38). |
| |
Connect the Upright Wire (38) to the Bridge Wire | 52 | |
(52). Make sure to connect the connectors | 38 | |
properly (see the inset drawing). The connec- | ||
tors should slide together easily and snap | 78 | |
into place. If they do not, turn one connector and | ||
| ||
try again. IF THE CONNECTORS ARE NOT |
| |
CONNECTED PROPERLY, THE CONSOLE | Wire Tie | |
MAY BE DAMAGED WHEN THE POWER IS |
| |
TURNED ON. |
|
|
|
| 52 |
|
|
| 38 |
9. Insert the indicated connectors and tie into the | 9 |
|
|
Right Upright (78). |
|
| |
|
|
| |
Next, insert the fronts of the brackets on the |
| 95 |
|
|
|
| |
Bridge (95) into the Uprights (74, 78), and then |
|
|
|
fully insert the brackets. Make sure that the plas- |
|
|
|
tic edges of the Bridge (95) are inside the |
|
| Connectors |
Uprights. |
| 7 |
|
|
|
| |
Attach the Bridge (95) with six 1/4" x 1/2" Bolts |
| 10 | Front |
7 |
| ||
|
| ||
(7) and six 1/4" Star Washers (10); start all six |
|
| |
| Edge |
| |
Bolts and then tighten them. |
|
| |
| 7 |
| |
|
|
| |
See steps 4 and 6. Tighten the four 3/8" x 4 1/2" | 74 |
|
|
Bolts (6). | 10 |
| |
|
| ||
|
| 7 | Tie |
|
|
| 78 |
10.With the help of a second person, hold the con- | 10 |
|
|
sole assembly near the Bridge (95). Connect the |
|
| |
|
|
| |
Bridge Wire (52) to the console assembly wire. | Console |
| |
Make sure to connect the connectors prop- |
| ||
Assembly |
| ||
erly (see the inset drawing in step 8). The |
| ||
|
|
| |
connectors should slide together easily and |
|
|
|
snap into place. If they do not, turn one connec- |
|
|
|
tor and try again. IF THE CONNECTORS ARE |
|
|
|
NOT CONNECTED PROPERLY, THE CON- | 101 |
| |
SOLE MAY BE DAMAGED WHEN THE |
| ||
| 52 |
| |
POWER IS TURNED ON. | 95 |
| |
|
|
| |
Connect the Console Ground Wire (101) to the |
| 9 |
|
console assembly ground wire. Insert the wires |
|
|
|
into the console assembly. |
| 5 |
|
|
|
| |
Attach the console assembly with three 3/8" x |
|
|
|
1 1/4" Bolts (5) and three 3/8" Star Washers (9). |
|
|
|
Be careful not to pinch the wires. |
|
|
|
| 9 |
|
|