NordicTrack NTL09107.0 user manual Make sure that the power cord is unplugged

1. Make sure that the power cord is unplugged.	1
With the help of a second person, carefully tip			B
			A
the treadmill onto its left side. Partially fold the
Frame (56) so that the treadmill is more stable;			Hole
do not fully fold the Frame yet.
		38	83
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).			81
Cut the tie securing the Upright Wire (38) to the
Base (83). Locate the tie in the indicated hole in			2
the Base, and use the tie to pull the Upright Wire
out of the hole.
Attach a Base Pad (81) to the Base (83) in the		13
location shown with a Base Pad Spacer (13) and	56
a #8 x 1" Tek Screw (2). Then, attach another		81
		2
Base Pad (81) with only a #8 x 1" Tek Screw (2).
2. Remove the 3/8" Nut (8), the 3/8" x 2" Bolt (4),	2
and the shipping bracket (C) from the Base (83).
Attach a Wheel (84) with the Bolt and the Nut
that you just removed. Do not overtighten the
Nut; the Wheel must turn freely. Discard the		83
shipping bracket.
		4
		84
		C
		8
3. Identify the Right Upright (78) and the Right	3
Upright Spacer (79), which are marked with
	38		78
stickers. Insert the Upright Wire (38) through the
Right Upright Spacer as shown. Set the Spacer
on the Base (83).
		Wire Tie	38
See the inset drawing. Tie the wire tie in the			79
Right Upright (78) securely around the end of
			83
the Upright Wire (38). Be sure that the wire tie
goes through the indicated hole in the Right
Upright.
With the help of a second person, hold the Right
Upright (78) near the Base (83). Then, pull the		78
other end of the wire tie until the Upright Wire
		Hole
(38) is routed completely through the Right
Upright.	38	Wire
		Tie
	7