NordicTrack NTL18907.0 user manual Bly. Make sure to connect the connectors

2. Attach the four Base Pads (81) to the bottom of	2
the Upright (20) with the four 1” Tek Screws (82)
in the locations shown.
		82	81
			81
			82
		82
			81
			20
			81
			82
3. Remove the band securing the Upright Wire	3
Harness (73) to the right Upright (20). Have a
second person hold the console assembly near
the right Upright.			Console
			Assembly
Connect the Upright Wire Harness (73) to the
console wire extending from the console assem-
bly. Make sure to connect the connectors			Console Wire
properly (see the inset drawing). The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector			73
and try again. IF THE CONNECTORS ARE NOT
CONNECTED PROPERLY, THE CONSOLE
MAY BE DAMAGED WHEN THE POWER IS
TURNED ON. Then, insert the connectors into
the right Upright (20).			20
			73
4. Carefully set the console assembly onto the top	4		Console Assembly
of the Upright (20) as shown. Make sure that no
wires are pinched. Attach the console assem-
bly to the Upright with four Star Washers (67)
and four Handrail Bolts (72). Start all four
Handrail Bolts before tightening them.

72

67 67

20

7