5.Attach the Latch Housing (34) to the left Upright (20) with two Screws (7); start both Screws and then tighten them. Note: Make sure that the large hole in the Latch Housing is on the indicated side.
Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two collars, place one on each side of the spring.) Next, insert the pin into the Latch Housing (34). Then, tighten the knob onto the pin.
6.With the help of a second person, raise the Walking Platform (15) to the storage position and make sure that the latch pin is engaged as de- scribed on page 24.
Position the Base Plate (75) on the treadmill as shown. Attach the Base Plate to the Upright (20) with the three Base Plate Bolts (77). Note: It may be helpful if a second person tips the treadmill slightly as you tighten the Bolts.
Carefully lower the Walking Platform (15) to the floor as described on page 25.
5 |
|
34 | 20 |
Knob |
|
7 | Spring |
| |
Large Hole | Collar |
| |
| Pin |
6 |
|
| 15 |
77 |
|
75
20
7.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key in a secure place. The hex key is used to adjust the walking belt (see page 27). To protect the floor or car- pet from damage, place a mat under the treadmill.
8