2.With the help of another person, carefully raise the Uprights (117) to the vertical position, with the wheels and the walking platform on the floor as shown on page 5.
Insert a Handgrip Post (41) into the tube on top of the left Upright (117). If necessary, tap the Handgrip Post with a rubber mallet to make sure that it is fully seated. Then, tighten four 1/2” Tek Screws (22) several turns into the tube and the Handgrip Post. Do not fully tighten the Tek
Screws yet.
Attach the other Handgrip Post (41) to the right Upright (not shown) as described above.
3.Have another person hold the Console Base (52) near the Uprights (117). Locate the wire harness extending from the Console Base. Connect the wire harness to the Wire Harness (55) in the Right Upright. The connectors should slide together easily and snap into place. If the connectors do not slide easily and snap into place, turn one connector and then insert it. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
Carefully feed the connectors and the excess wire har- ness into the Right Upright (117). Then, carefully set the Console Base (52) on the Uprights. Be careful not to pinch the wire harnesses.
Tighten four Console Bolts (42) with Star Washers (113) two to four turns into the Uprights (117) and the Console Base (52). After all four Console Bolts have been started, tighten them.
4.See the inset drawing. Identify the Right Top Handgrip
(53)(there are identifying marks inside of the Handgrips). Set the Right Top Handgrip on the right Handgrip Post
(41).Insert two 1/2” Screws (51) into the two holes in the Handgrip Post indicated by the arrows. Tighten the Screws into the Right Top Handgrip.
Important: Be careful not to insert the two 1/2” Screws (51) into the wrong holes in the Handgrip Post (41), or tighten the Screws into the plastic bosses on the bottom of the Right Top Handgrip (53).
Slide the front of the Right Top Handgrip (53) against the Console Base (52). Then, firmly tighten the four 1/2” Tek Screws (22) (only two are shown).
2 |
|
|
|
|
|
|
| 41 |
|
|
| 22 |
|
|
|
|
| 22 |
|
|
| 117 |
|
|
3 | Wire Harness |
|
| |
|
|
| ||
|
|
|
| 55 |
113 |
|
|
| |
|
| 55 |
|
|
42 |
| 117 | 52 |
|
|
|
|
| |
|
|
| 113 |
|
|
|
| 42 |
|
4 |
| Front | 52 |
|
|
|
| Left | Right |
Bosses |
| 21 | 53 | |
|
|
| ||
53 |
|
|
|
|
41 |
| 22 |
|
|
|
| 51 |
|
|
7