5.Attach the matching Right Bottom Handgrip (54) with three 1/2” Screws (51).
Attach the Left Top Handgrip (not shown) and the Left Bottom Handgrip (not shown) as described above.
6.Attach the Latch Assembly (37) and the Latch Spacer (39) to the Left Bottom Handgrip (40) with two Latch Screws (36). Firmly tighten the Latch Screws. Note: The ridge on the Latch Spacer must be on the side shown.
If there are plastic ties around the left and right Pulse Sensor Plates (2), cut off the plastic ties.
7.To protect the floor or carpet from damage, place the in- cluded Mat (66) under the front of the treadmill.
Note: If the treadmill rocks slightly, tip the treadmill onto its side. See step 1. Loosen the four Base Leg Bolts (77), ad- just the positions of the Base Legs (78), and then retighten the Base Leg Bolts. Raise the treadmill back to the vertical position. Repeat until the rocking motion is eliminated.
5 |
| |
54 |
| |
| 51 | |
6 |
| |
Ridge |
| |
39 | 2 | |
40 | ||
| ||
37 |
| |
| 36 | |
7 |
| |
| 66 |
8.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 25). To protect the floor or carpet from damage, place a mat under the treadmill. Extra parts may be included.
Note: The underside of the treadmill walking belt is coated with
8