Juniper Networks EX2200 manual AC Power Cord Specifications

Complete Hardware Guide for EX2200 Ethernet Switches

CAUTION: The AC power cord for each switch is intended for use with that switch only and not for any other use.

NOTE: In North America, AC power cords must not exceed 4.5 meters (approximately 14.75 feet) in length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian Electrical Code (CEC) Section 4-010(3). The cords supplied with the switch are in compliance.

Table 21 on page 48 lists AC power cord specifications provided for each country or region.

Table 21: AC Power Cord Specifications

Country/Region	Electrical Specifications	Plug Standards
Australia	250 VAC, 10 A, 50 Hz	AS/NZ 3112
China	250 VAC, 10 A, 50 Hz	GB2099 and GB1002
Europe (except Italy, Switzerland, and	250 VAC, 10 A, 50 Hz	CEE (7) VII
United Kingdom)
Italy	250 VAC, 10 A, 50 Hz	CEI 23-16
Japan	125 VAC, 12 A, 50 Hz or 60 Hz	JIS C8303
North America	125 VAC, 13 A, 60 Hz	NEMA 5-15
Switzerland	250 VAC, 10 A, 50 Hz	SEV 1011 SEV 6534/2
United Kingdom	250 VAC, 10 A, 50 Hz	BS 1363/A

Figure 13 on page 48 illustrates the plug on the power cord for each country or region listed in Table 21 on page 48.

Figure 13: AC Plug Types

Related • Power Supply in EX2200 Switches on page 14

Documentation

• General Safety Guidelines and Warnings for EX Series Switches on page 113

• General Electrical Safety Guidelines and Warnings for EX Series Switches on page 141

• Prevention of Electrostatic Discharge Damage on EX Series Switches on page 142

48 Copyright © 2010, Juniper Networks, Inc.