Chapter 10: Connecting the Switch
The boot process proceeds as normal and ends with a login prompt.
Configuring the Modem
Before you connect the modem, you must configure the modem with required port settings.
NOTE:
To configure the modem:
1.Connect the modem to the desktop or notebook computer.
2.Power on the modem.
3.From the computer, start your asynchronous terminal emulation application (such as Microsoft Windows HyperTerminal) and select the COM port to which the modem is connected (for example, COM1).
4.Configure the port settings shown in Table 23 on page 79.
Table 23: Port Settings
Port Settings | Value |
Bits per second | 115200 |
Data bits | 8 |
Parity | None |
Stop bits | 1 |
Flow control | None |
5.In the HyperTerminal window, type at. Press Enter.
The modem sends an OK response to verify that it can communicate successfully with the COM port on your desktop or notebook computer.
6.To configure the modem to answer a call on the first ring, type ats0=1 at the prompt. Press Enter.
7.To configure the modem to accept
8.To disable flow control on the modem, type at&k0 at the prompt. Press Enter.
9.To set the fixed serial port speed on the modem, type at&b1 at the prompt. Press Enter.
Copyright © 2010, Juniper Networks, Inc. | 79 |
