Juniper Networks EX2200 manual Transceiver

Complete Hardware Guide for EX2200 Ethernet Switches

Figure 35: Connecting a Fiber-Optic Cable to an Optical Transceiver

Installed in an EX Series Switch

Transceiver

g027016

Fiber-optic cable

4.Secure the cables so that they are not supporting their own weight. Place excess cable out of the way in a neatly coiled loop. Placing fasteners on a loop helps cables maintain their shape.

CAUTION: Do not bend fiber-optic cables beyond their minimum bend radius. An arc smaller than a few inches in diameter can damage the cables and cause problems that are difficult to diagnose.

Do not let fiber-optic cables hang free from the connector. Do not allow fastened loops of cables to dangle, which stresses the cables at the fastening point.

Related • Disconnecting a Fiber-Optic Cable from an EX Series Switch on page 97

Documentation

• Installing a Transceiver in an EX Series Switch on page 65

• Maintaining Fiber-Optic Cables in EX Series Switches on page 101

• Optical Interface Support in EX2200 Switches on page 22

• Optical Interface Support in EX3200 Switches

• Optical Interface Support in EX4200 Switches

• Optical Interface Support in EX4500 Switches

• Optical Interface Support in EX8200 Switches

82 Copyright © 2010, Juniper Networks, Inc.