Juniper Networks EX2200 manual Performing Initial Configuration

Chapter 11: Performing Initial Configuration

Connecting and Configuring an EX Series Switch (J-Web Procedure)

There are two ways to connect and configure an EX Series switch: one method is through the console using the CLI and the other is using the J-Web interface. This topic describes the J-Web procedure.

NOTE: Before you begin the configuration, enable a DHCP client on the management PC you will connect to the switch so that the switch can obtain an IP address dynamically.

NOTE: Read the following steps before you begin the configuration. You must complete the initial configuration using EZSetup within 10 minutes. The switch exits EZSetup after 10 minutes and reverts to the factory default configuration, and the PC loses connectivity to the switch.

•EX2200 switch—The LEDs on the network ports on the front panel blink when the switch is in the initial setup mode.

•EX3200, EX4200, EX4500, or EX8200 switch—The LCD displays a count-down timer when the switch is in initial setup mode.

Copyright © 2010, Juniper Networks, Inc. 89