Juniper Networks EX2200 manual Retainer clip Adjustment nut

Complete Hardware Guide for EX2200 Ethernet Switches

4.Push the power cord into the slot in the adjustment nut of the power cord retainer clip. Turn the nut until it is tight against the base of the coupler and the slot in the nut is turned 90° from the top of the switch (see Figure 28 on page 74).

5.If the AC power source outlet has a power switch, set it to the OFF (0) position.

6.Insert the power cord plug into an AC power source outlet.

7.If the AC power source outlet has a power switch, set it to the ON () position.

Figure 27: Connecting an AC Power Cord Retainer Clip to the AC Power

Cord Inlet on an EX2200 Switch

Retainer clip Adjustment nut

g027013

Figure 28: Connecting an AC Power Cord to the AC Power Cord Inlet on an EX2200 Switch

Tighten adjustment nut.

		g027014
Related	•	Connecting and Configuring an EX Series Switch (CLI Procedure) on page 87
Documentation	•	Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 89

• Power Supply in EX2200 Switches on page 14

Connecting an EX Series Switch to a Network for Out-of-Band Management

This topic applies to multiple hardware devices in the EX Series product family, which includes switches and the XRE200 External Routing Engine.

You can monitor and manage these devices using a dedicated management channel. Each device has a management port with an RJ-45 connector for out-of-band management. Use the management port to connect the EX Series switch or external Routing Engine to the management device.

Ensure that you have an Ethernet cable with an RJ-45 connector available. One such cable is provided with the device. Figure 29 on page 75 shows the RJ-45 connector of the Ethernet cable supplied with the device.

74 Copyright © 2010, Juniper Networks, Inc.