CHAPTER 11
Performing Initial Configuration
•EX2200 Switch Default Configuration on page 83
•Connecting and Configuring an EX Series Switch (CLI Procedure) on page 87
•Connecting and Configuring an EX Series Switch
EX2200 Switch Default Configuration
Each EX Series switch is programmed with a factory default configuration that contains the values set for each configuration parameter when a switch is shipped. The default configuration file for an EX2200 switch configures Ethernet switching and storm control on all interfaces, configures Power over Ethernet (PoE) on all interfaces of models that provide PoE, and enables the LLDP,
When you commit changes to the configuration, a new configuration file is created that becomes the active configuration. You can always revert to the factory default configuration. See Reverting to the Default Factory Configuration for the EX Series Switch.
The following factory default configuration file is for an EX2200 switch with 24 ports, all of which have PoE capability:
NOTE: For models that have more than 24 ports, this default configuration file has more interfaces. For models without PoE, the poe stanza does not appear. All models have four uplink ports as listed below,
interface all { level 50;
}
}
}
protocols {
vlan all;
}
lldp { interface all;
}
Copyright © 2010, Juniper Networks, Inc. | 83 |
