Juniper Networks EX2200 specs

•A phone cable (not provided)

•If your computer does not have a DB-9 male connector pin, a USB to DB-9 male adapter (not provided)

•An adapter to connect the RS-232 DB-25 connector on the modem to the RJ-45 to DB-9 adapter on the switch (not provided)

This topic describes:

1.Setting the Serial Console Speed for the Switch on page 78

2.Configuring the Modem on page 79

3.Connecting the Modem to the Console Port on page 80

Setting the Serial Console Speed for the Switch

Before you can connect the switch to a modem, the switch’s serial console speed must be set to 115200 baud.

NOTE: The default serial console speed is 9600 baud.

To change the serial console speed:

1.Power on the switch. (If the switch is an EX8208 or EX8216 model, see Powering On an EX8200 Switch.) The loader script starts.

2.You are prompted with:

Hit [Enter] to boot immediately, or space bar for command prompt.

Press the Spacebar to pause the switch in the loader state (after the Junos OS has loaded on the switch but before the software starts).

The loader> prompt appears.

3.Set the baud rate:

loader> set baudrate=115200

Press Enter.

4.Press Enter when you see the following message:

Switch baud rate to 115200 bps and press Enter.

The loader> prompt reappears.

5.Save the new serial console speed: loader> save

Press Enter. The serial console speed is now set to 115200 baud.

6.Boot the software: loader> boot

78	Copyright © 2010, Juniper Networks, Inc.