Juniper Networks manual EX2200 Switch Hardware and CLI Terminology Mapping

Chapter 1: EX2200 Switch Overview

•Serial number ID label

•AC power cord inlet

Figure 3 on page 7 shows the rear panel of an EX2200 switch.

All EX2200 switches have three exhaust openings on the rear panel. The two leftmost exhaust openings have fans behind them and are open. The rightmost exhaust opening is open on Power over Ethernet (PoE) models and closed on non-PoE models. On PoE models, this opening exhausts the air from the fan at the air intake for the power supply on the side panel.

The power cord retainer clips extend out of the chassis by 3 in.

Figure 3: Rear Panel of an EX2200 Switch

Management	Protective	ESD	Air intake with fan for power supply
Ethernet port	earthing terminal	point	(fan on PoE models only)

EX2200-24-4G REV: X1
750-026464 REV: X3	Mfg. Date
	20090227

MAC: 00:23:9C:oE:19:00

MADE IN CHINA

g027001

USB	Console			Air exhaust	Air exhaust without fan	Serial number	AC power
port	port			with fan	(closed on non-PoE models)	ID label	cord inlet
Related		•	Front Panel of an EX2200 Switch on page 5
Documentation		•	USB Port Specifications for an EX Series Switch on page 19

• Cooling System and Airflow in an EX2200 Switch on page 15

• Power Supply in EX2200 Switches on page 14

• Prevention of Electrostatic Discharge Damage on EX Series Switches on page 142

• Connecting Earth Ground to an EX Series Switch on page 67

• Installing and Connecting an EX2200 Switch on page 51

EX2200 Switch Hardware and CLI Terminology Mapping

This topic describes the hardware terms used in EX2200 switch documentation and the corresponding terms used in the Junos OS command line interface (CLI). See Table 3 on page 8.

Copyright © 2010, Juniper Networks, Inc. 7