
CHAPTER 9
Installing Switch Components
•Installing a Transceiver in an EX Series Switch on page 65
Installing a Transceiver in an EX Series Switch
The transceivers for EX Series switches are
Use only optical transceivers and optical connectors purchased from Juniper Networks for your EX Series switch.
NOTE: On an EX3200 switch, if you install a transceiver in a
Before you begin installing a transceiver in an EX Series switch, ensure that you have taken the necessary precautions for safe handling of lasers (see “Laser and LED Safety Guidelines and Warnings for EX Series Switches” on page 121).
Ensure that you have a rubber safety cap available to cover the transceiver.
Figure 24 on page 66 shows how to install an SFP transceiver. The procedure is the same for all transceiver types.
To install a transceiver in an EX Series switch:
CAUTION: To avoid electrostatic discharge (ESD) damage to the transceiver, do not touch the connector pins at the end of the transceiver.
1.Remove the transceiver from its bag.
2.Check to see whether the transceiver is covered by a rubber safety cap. If it is not, cover the transceiver with a rubber safety cap.
Copyright © 2010, Juniper Networks, Inc. | 65 |