Reebok Fitness RBTL69920 manual Enter your age, Decrease

During heart rate pro- grams, the program display will show a graphic that represents your heart rate. Each time a heartbeat is de- tected, an additional peak will appear.

4 Enter your age.

When a heart rate pro-

gram is selected, the let- ters AGE and the current age setting will begin to

flash in the Calories/ Fat Calories/Heart Rate

display. You must enter your age to use a heart rate program. If you have already entered your age, go to step 5. If you have not entered your age, press the Incline (Age Set) buttons until your age is shown. Your age will then be saved in mem- ory.

5	Press the Start button or the Speed	▲ button to
	start the program.

A moment after the button is pressed, the tread- mill will automatically adjust to the first speed and incline settings for the program. Hold the handrails and begin walking.

Each heart rate program is divided into one-minute

segments.	The Time/Incline/Segment Time display
will show both the time remaining in the program
and the time remaining in the current segment of
the program. One target heart rate setting is pro-
grammed for each segment. (		The same target

heart rate setting may be programmed for consecu- tive segments.)

When only three seconds remain in the first one- minute segment of the program, a series of tones will sound and the Time/Incline/Segment Time display and the Speed/Min-Mile display will flash.

The speed and/or incline of the treadmill will then change, if needed, to bring your heart rate closer to the target heart rate setting for the next segment. The program will continue until no time remains in the program. The walking belt will then slow to a stop.

	If the speed or incline setting for the current seg-
	ment is too high or too low, you can adjust the set-
	ting with the Speed or Incline buttons. However, if
	you	decrease		the speed, the incline will automati-
	cally	increase		; if you increase			the speed, the in-
	cline will		decrease		. If you increase			the incline, the
	speed will			decrease		; if you decrease		the incline,
	the speed will			increase		. The treadmill will always
	attempt to keep your heart rate near the target
	heart rate setting for the current segment.							Note:
	When the incline reaches the lowest setting, the
	speed cannot be increased any further. When the
	incline reaches the highest setting, the speed can-
	not be decreased any further.
	If your pulse is not detected during the program,
	the letters PLS will flash in the Calories/Fat
	Calories/Heart Rate display and the speed and in-
	cline of the treadmill may automatically decrease
	until your pulse is detected. If this occurs, refer to
	the instructions on page 10.
	To stop the program at any time, press the Stop
	button. Heart rate programs should not be stopped
	temporarily and then restarted. To use a heart rate
	program again, reselect the program and start it at
	the beginning.
	Follow your progress with the displays.
6
	Refer to step 5 on page 13.
	When the program is completed, remove the
7
	key from the console.

Refer to step 6 on page 16.

17