11.See drawing 11a. Remove the indicated 3/4" Screw (7) from the right Handrail (70).
See drawing 11b. Slide the Right Upright Sleeve (9) up to the console assembly. Attach the Right Upright Sleeve with two 1" Tek Screws (82) and the 3/4" Screw (7) as shown.
Attach the Left Upright Sleeve (not shown) in the same way.
11a
70 
7 
11b Console
Assembly
7
9
82
12. With the help of a second person, carefully |
|
|
|
|
| 12 |
|
| |
|
|
| ||
lower the Uprights (85) to the position shown. |
|
|
| |
|
|
|
| |
|
|
|
|
|
Attach the Right Base Cover (86) with three 3/4" Screws (7) and two Base Cover Screws (63).
Start all five Screws and then tighten them. Be careful not to overtighten the Screws. Attach the Left Base Cover (88) in the same way.
With the help of a second person, carefully raise the Uprights (85) to the vertical position.
85 
7 86
63
88
7 |
63 |
13.Note the location of the 75 ohm antenna terminal on the treadmill. For the television to operate properly, an antenna, a CATV cable, or a VCR must be connected to the 75 ohm antenna termi- nal (see page 13).
13
75 Ohm
Antenna
Terminal
14.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key in a secure place. The hex key is used to adjust the walking belt (see page 30). To protect the floor or car- pet from damage, place a mat under the treadmill.
11