TROUBLESHOOTING THE TREADMILL (CONTINUED)
Malfunction | Probable Cause | Corrective Action |
|
|
|
Striding Belt slips | Uneven floor surface. | Check levelers and level tread- |
|
| mill. |
|
| Check striding belt & |
|
| as necessary. Refer to Section |
|
| 6.5 “How to Adjust and Tension |
|
| the Striding Belt.” |
|
|
|
Maximum speed is reduced | User is pushing striding belt. | Instruct users not to push striding |
| This occurs when the runner is | belt in either direction. |
| running faster than the striding |
|
| belt will travel, with the result of |
|
| the striding belt being pushed |
|
| with the runner’s feet. |
|
|
|
|
| User is stalling striding belt. |
|
| This will occur with heavier users |
|
| at lower striding belt speeds. The |
|
| striding belt will “stall” if the user |
|
| is traveling slower than the strid- |
|
| ing belt speed. |
|
|
|
|
| Striding belt/deck malfunction. | Replace belt and deck. |
| The deck laminate worn through |
|
| or the underside of striding belt |
|
| glazed over (hard, glossy). |
|
|
|
|
| Insufficient power source. | Plug treadmill into a dedicated 20 |
|
| amp. circuit. |
Rubbing sound from underneath | Foreign objects may be stuck | Inspect underneath striding belt |
machine | underneath the machine. | and machine. Remove any debris |
|
| or objects that may cause inter- |
|
| ference with the treadmill. |
|
|
|
| Tinsel is installed incorrectly. | Reposition tinsel on the outside |
|
| of the striding belt. |
|
|
|
Display does not illuminate when | Loose 10 pin connection at | Check all electrical connections |
machine is powered on | display console or DSP motor- | for proper attachment. |
| control board. | Contact Life Fitness Customer |
|
| |
|
| Support Services*. |
|
|
|
* See Section 6.6 “How to Obtain Product Service” for contact information.
34