Troubleshooting

TR3000i / TR4000i

Folding Treadmill

The treadmill is designed and manufactured to be reliable and easy to use. However, if you have a problem, these troubleshooting steps may help you nd the cause.

Problem:	The console is erratic or not lighting up
Solution:	Check to make sure that the treadmill is properly plugged in, turn the power
	switch o and back on again and make sure the safety key is in place. If the
	problem persists contact LifeSpan Customer Service.
Problem:	The belt does not stay in the center of the treadmill when in use.
Solution:	First check to make sure that the treadmill is level, then refer to the instructions in
	this manual on how to tension and adjust the belt.
Problem:	The treadmill motor seems strained or E1 comes up after several minutes of use.
Solution:	The lubricating silicone that is applied to the deck and belt is wearing down and
	the belt needs to be lubricated with silicone spray.
Problem:	The treadmill belt slips during use.
Solution:	The belt may need to be tensioned after a period of use. Refer to the Belt
	Tensioning and Adjustment Section of this manual.
Problem:	Speed does not match quick keys. Treadmill Starts at 1 and goes to 16.
Solution:	The treadmill is set up in Metric Mode. See chart on next page for Console
	Engineering Mode.
Problem:	Heart Rate is erratic or not picking up.
Solution:	Make sure your hands are moist (Aloe Vera helps). Make sure all connectors at the
	back of the console are properly connected and no wires are damaged.
	If wearing a chest strap make sure the batteries are good and that the electrodes
	are moist and position properly on your chest.
Problem:	Treadmill automaticaly pauses during workout.
Solution:	Treadmill is not picking up Step Count. Go into Engineering Mode to turn Intelli
	Guard o.
Problem:	Silicon icon lights up on console.
Solution:	Lubricate the running belt with 100% pure silicone. Then simultaneously press
	and hold the Speed and Start buttons until the light turns o.