LifeSpan TR4000I, TR3000i manual Assemble Console Components, Attach Console Assembly

Step 3: Assemble Console Components

TR3000i / TR4000i

Folding Treadmill

A.Attach the blue accessory trays (6) to the bottom of the console housing using 8 self tapping screws (G).

B.Attach the console (5) to the console housing using 6 screws (G). These screws are pre-installed on the back of the

and then reinstalled with the console in place.

25

G

G

5

6

Step 4: Attach Console Assembly

A.Place the console assembly onto the console support bracket and attach the assembly using the 7 screws (F). Be sure not to pinch wire harnesses during this step.

B.Connect all wire harnesses including:

i.Main Harness: 5-pin and 7-pin

ii.Hand Pulse harness: 2-pin

iii.Speed Control Harness: 3-pin (the wire colors need to be matched.)

iv.Incline Control Harness: 3-pin (the wire colors need to be matched)

C.Tuck extra wiring harness into the opening behind the console.

24

F

Note: Be careful to properly connect all wiring connectors with their correct corresponding wiring harness. Pay attention not to bend any pins and make sure the connectors click in place.