Engineering Mode
Press STOP and then SPEED UP to enter the Engineering Mode. You can press ENTER/MODE to switch setup screens, or press STOP+SPEED UP to return to Standby Mode. The table below shows the sequence of the setup screens.
Engineering function | Information viewed on screen |
|
|
Press STOP and then Speed Up to enter the | Engineering Mode |
Engineering Mode. | 150 |
| |
(incline window shows software version) | 2009.06.18 |
Press Enter / Mode |
|
Guard automatically pauses the unit if it detects the treadmill is not being walked on. Press Speed/Incline Up/Down buttons 
Press Enter / Mode to show Roller diameter
Press Enter / Mode to set up the units of measurement | En or Si | |
in Metric (SI) or in English (EN). | ||
| ||
Press Speed/Incline or Up/Down to change |
|
Roller
625
Select the units
Press Enter / Mode to set up Calendar
Calendar Operation:
Press Enter / Mode for Distance
This is the total distance the treadmill has been run in Miles or Kilometers depending on what mode the treadmill is in.
Press Enter / Mode for Workout Time
This is the total number of hours the treadmill has been used.
Set Calendar On
Total Distance
0000
Total Hours
0000
Press Enter/Mode again to return to the standby mode.
44