ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrench | and your own phillips screwdriver | . |
For help identifying assembly hardware, see the drawings below. Note: If a part is not found in the part bags, check to see if the part has been preattached.
Nut | Washer | Star Washer |
Base Pad Spacer | ||
|
|
3/4” Screw | 1” Tek Screw | Upright Bolt |
|
|
Wheel Bolt
1.Identify the Right Upright (74), which has holes in the in- dicated locations.
Set the Right Upright (74) near the Frame (48) as shown. Insert the Upright Wire Harness (75) into the lower end of the Right Upright and out of the top.
Place an elastic band around the Upright Wire Harness (75) and the Right Upright (74) to keep the Upright Wire Harness from falling into the Right Upright. Leave the elastic band on until step 8 is completed.
1 |
|
|
| |
|
|
| Large | |
|
|
| Hole | |
| 75 | 74 | Small | |
48 | Holes | |||
| ||||
| Band |
|
|
6