Epic Fitness eptl20912.0 manual Troubleshooting, Symptom The power turns off during use

Page 28

TROUBLESHOOTING

Most treadmill problems can be solved by follow- ing the simple steps below. Find the symptom that applies, and follow the steps listed. If further assis- tance is needed, see the front cover of this manual.

SYMPTOM: The power does not turn on

a.Make sure that the power cord is plugged into a surge suppressor and that the surge suppressor is plugged into a properly grounded outlet (see page 12). Use only a surge suppressor that meets all of the specifications described on page 12.

IMPORTANT: The treadmill is not compatible with GFCI-equipped outlets and may not be compatible with AFCI-equipped outlets.

b.After the power cord has been plugged in, make sure that the key is inserted into the console.

c.Check the power switch located on the treadmill frame near the power cord. If the switch protrudes as shown, the switch has tripped. To reset the power switch, wait for five minutes and then press the switch back in.

c

Tripped

Reset

SYMPTOM: The power turns off during use

a.Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console, and then reinsert it.

d.If the treadmill still will not run, please see the front cover of this manual.

SYMPTOM: The console screen remains lit when you remove the key from the console

a.The console features a demo mode, designed to be used if the treadmill is displayed in a store. If the screen shows a demo presentation when you remove the key, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the screen is still lit, see step 7 on page 23 to turn off the demo mode.

SYMPTOM: The incline of the treadmill does not change correctly

a.Calibrate the incline system (see step 4 on page 24).

SYMPTOM: The iFit mode does not function correctly

a.If the iFit mode is not functioning correctly, make sure that the treadmill has the most current firm- ware available (see step 3 on page 24).

SYMPTOM: The treadmill will not connect to the wireless network

a.Make sure that the wireless settings on your con- sole are correct (see step 4 on page 25).

b.Make sure that the settings for your wireless net- work are correct.

c.If you still have questions, see the front cover of this manual.

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents QUESTIONS? Model No. EPTL20912.0 Serial NoVisit OUR Website CallTable of Contents Important Precautions Page Before YOU Begin Part Identification Chart Assembly Power cordSee the inset drawing. Press the left handrail Decal is on the side of the Cover as shownBe careful not to pinch the Upright Again. if YOU do not Connect the CON Connect the pulse wires on the right side not Shown alsoSide is shown. Start all four Screws and then Tighten them Page HOW to PUT on the Heart Rate Monitor Care and MaintenanceTroubleshooting Chest Heart Rate MonitorHOW to Connect the Power Cord Operation and AdjustmentUse a Surge Suppressor Features of the Console DiagramConsole HOW to Turn on the Power HOW to USE the Touch ScreenHOW to SET UP the Console HOW to USE the Manual Mode When you are finished exercising, remove Power cord. Important If you do not doKey from the console This, the treadmill’s electrical components maySelect an onboard workout HOW to USE AN Onboard WorkoutStart the workout HOW to USE a SET-A-GOAL Workout Select the main menu. See on Select a set-a-goal workoutHOW to Create a USER-DEFINED Workout Select a user-defined workoutHOW to USE a USER-DEFINED Workout Change the workout if desiredHOW to USE AN Ifit Workout Start the workout. See onHOW to USE the Equipment Settings Mode HOW to USE the Maintenance Mode HOW to USE the Wireless Network Mode Enable Wi-FiSet up and manage a wireless network connection Exit the wireless network modeMake sure that your audio wire is fully plugged HOW to USE the Stereo Sound SystemHOW to USE the Internet Browser HOW to Fold and Move the Treadmill HOW to Fold the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USESymptom The power turns off during use TroubleshootingSymptom The iFit mode does not function correctly Symptom The walking belt slows when walked on Cleaning MaintenanceStorage Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencySuggested Stretches Part List Qty DescriptionDescription Qty Exploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Exploded Drawing E Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents