ASSEMBLY
• To watch an assembly video, go to http://productvideo.co/ assembly/dsg/epic or use your mobile phone or smartphone to read the QR code at the right.
•Assembly requires two persons.
•Place all parts in a cleared area and remove the packing materials, except for the packing materi- als on the upright. Do not dispose of the packing materials until you finish all assembly steps.
•After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild,
•Left parts are marked “L” or “Left” and right parts are marked “R” or “Right.”
•To identify small parts, see page 6.
•Assembly requires the following tools:
the included hex keys two adjustable wrenches
To avoid damaging parts, do not use power tools.
1. Make sure that the power cord is unplugged. | 1 |
|
|
Also, make sure to assemble the treadmill in |
|
| |
|
|
| |
the location where it will be used. If there is a |
|
| A |
strap around the treadmill, remove it. |
|
| |
|
|
| |
With the help of a second person, hold both |
|
|
|
sides of the Upright (96) securely and remove |
|
|
|
the packing materials (A) at the same time. |
|
|
|
Then, carefully raise the Upright (96) into the |
|
|
|
vertical position so that the base of the Upright |
|
|
|
rests flat on the floor. Be careful not to pinch | A | 96 |
|
the power cord. | Base | ||
2. Identify the left leg extension assembly (B). | 2 |
|
|
Insert the extension assembly into the left side of |
|
| |
|
|
| |
the Upright (96). Attach the extension assembly | 96 |
|
|
with two 5/16" x 3/4" Screws (1). Firmly tighten |
|
| |
the Screws. |
|
|
|
Attach the right leg extension assembly (not |
|
|
|
shown) to the right side of the Upright (96) in |
|
|
|
the same way. |
|
| 1 |
|
| B |
|
| 7 |
|
|