8. Have a second person hold the console assem- | 8 |
| Console |
|
|
|
bly near the Pulse Bar (66). Connect the |
|
|
|
| ||
Console Ground Wire (102) on the Pulse Bar to |
|
| Assembly |
|
| |
the ground wire from the console assembly. |
|
|
|
|
|
|
Connect the console wire to the Upright Wire |
|
|
|
|
|
|
(75). See the inset drawing. The connectors | Ground |
|
|
|
| |
should slide together easily and snap into |
|
|
|
| ||
place. If they do not, turn one connector and | Wire |
|
|
| 75 |
|
then try again. IF THE CONNECTORS ARE |
|
|
|
|
| |
NOT CONNECTED PROPERLY, THE CON- |
|
|
|
|
|
|
SOLE MAY BE DAMAGED WHEN THE |
| 102 |
|
|
|
|
POWER IS TURNED ON. Lay the wires inside |
|
|
| Console Wire | ||
the bottom of the Pulse Bar (66). |
| 66 |
|
| ||
|
| 76 |
| 75 |
| |
|
|
|
|
|
| |
9. Set the console assembly on the Left and Right | 9 |
|
|
|
|
|
Uprights (70, 76). Be careful not to pinch any |
| Console Assembly |
| |||
wires. |
|
|
| |||
Attach the console assembly to the Pulse Bar |
|
|
|
|
|
|
(66) with six 3/4" Screws (23). Start all six |
|
|
|
|
|
|
Screws before fully tightening any of them. |
|
|
|
|
|
|
|
|
| 66 |
|
|
|
|
| 23 | 23 | 23 | 76 | |
|
| 70 |
|
|
| |
10. Identify the Left Handrail Cover (68), which has | 10 | Console |
|
|
|
|
a LEFT sticker on it. Slide the Left Handrail |
|
|
|
| ||
Cover onto the left Handrail (62) and hold it |
| Assembly |
|
|
| |
against the console assembly. Tighten two |
|
|
|
|
|
|
Cover Screws (52) into the Left Handrail Cover |
|
|
|
|
|
|
and the Left Upright (70); be careful not to |
| 68 |
|
|
|
|
overtighten the Cover Screws. | 62 |
|
|
|
| |
Attach the Right Handrail Cover (74) in the |
|
|
|
|
| |
same way. |
| 52 | 70 |
|
|
|
|
|
| 74 |
| ||
|
|
|
| 62 |
| |
|
|
|
|
|
| |
| 9 |
|
|
| 52 | 76 |
|
|
|
|
|
|