TROUBLE-SHOOTING and Maintenance

Most treadmill problems can be solved by following the instructions below. If further assistance is needed, please call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEMSOLUTION

1.The power does not turn on

a.Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into a properly grounded outlet. (See page 7.) Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.

b.Make sure that the key is fully inserted into the console.

c.Check the circuit breaker located on the frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

d.Check the on/off switch located on the frame near the power cord. The switch must be in the on posi- tion.

Tripped Reset

Position

2.The power turns off during use

a.Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in.

c.Remove the key from the console and then reinsert it.

d.Make sure that the on/off switch is in the on position (see 1. d. above).

3. The walking belt	a. Make sure that only an appropriate surge protector is used (see 1. a. above).
slows when walked
on	b. If the walking belt is overtightened, tread-	b
	mill performance may decrease and the	b
	mill performance may decrease and the
	walking belt may be permanently dam-	3Ð4Ó
	aged. Remove the key and UNPLUG THE
	POWER CORD. Using the included allen
	wrench, turn both rear roller adjustment
	bolts counterclockwise 1/4 of a turn. When
	the walking belt is properly tightened, you
	should be able to lift the edges of the	Rear Roller Adjustment Bolts
	walking belt 3 to 4 inches off the walking
	platform. Be careful to keep the walking
	belt centered. Plug in the power cord, insert the key and run the treadmill for a few
	minutes. Repeat until the walking belt is properly tightened.