Assembly

To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own phillips screwdriver , wire cutters , and rubber mallet .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

To identify small parts during assembly, use the part identification drawings below.

3/4” Tek Screw (65)–2	1” Tek Screw (100)–4	1 1/4” Tek Screw (118)–2
Nut (20)–2
Foot Screw (74)–2	Wheel Bolt (94)–2
Handrail Star
Washer (77)–2
Console Bolt (78)–2

1.With the help of a second person, carefully raise the Uprights (69) to the position shown.

Next, insert one of the Extension Legs (102) into the base of the Uprights (69) as shown. Make sure that the

Extension Leg is turned so the Base Pad (99) is un- derneath it. Note: It may be helpful to tip the Uprights for- ward and use a rubber mallet to fully insert the Extension Leg.

Insert the other Extension Leg (not shown) in the same way.

102