Middleby Marshall PS300F English, V. Tandem Oven Assembly, Figure Oven Positioning and Alignment

ENGLISH

SECTION 2 - INSTALLATION

V. TANDEM OVEN ASSEMBLY

NOTE

For non-tandem oven installations, skip ahead to Section VI, Conveyor Installation.

1.Determine the proper position of the ovens by referring to Figure 2-7. Then, move the ovens to their approximate final locations.

2.Check that the top and bottom air finger retaining screws are present on all mating ends of the oven sections. See Figure 2-7. The screws prevent the air fingers from sliding in between the oven sections.

3.Remove the rear axial cooling fans that are adjacent to the mating sides of the ovens. The fans may either be completely disconnected, or left attached by their wiring as shown in Figure 2-8.

Figure 2-7

Oven Positioning and Alignment

LEFTOVEN RIGHTOVEN

Alignment

plateAir finger retaining

screws

Slot for

alignment

plate

Sealing gasket

assembly

(pre-mounted)

NOTE: The Sealing Gasket Assembly may

be pre-mounted to EITHER of the oven

cavities.

Figure 2-8 - Cooling Fan Removal

Mating surface of

ovens (shown

from lower rear)

Wiring is still connected

10