Healthrider HRTL89406.2 manual Troubleshooting, Problem The power turns off during use

Page 26

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the front cover of this manual.

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 12). Use only a single-outlet surge suppres- sor that meets all of the specifications described on page 12. Important: The treadmill is not com- patible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is inserted into the console.

c. Check the reset/off circuit breaker located on the treadmill frame near the power cord. If the switch pro- trudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch to the reset position.

PROBLEM: The power turns off during use

c

Tripped

Reset

SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch to the reset position.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c. Remove the key from the console. Reinsert the key into the console.

d. If the treadmill still will not run, see the front cover of this manual.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and UNPLUG THE

POWER CORD. Next, carefully lower the Uprights a (85). Remove the two indicated Belly Pan Screws (113). Note: A phillips screwdriver with a shaft at least

8” long is needed.

	85	113
	85
Raise the Uprights (85) to the vertical position.		7
Remove the three 3/4” Screws (7) from the Hood (33),	85	7	85
and carefully pivot the Hood off.
		33

26

Image 26

Contents Call TOLL-FREE QUESTIONS?Model No. HRTL89406.2 Serial No Table of Contents Important Precautions Page Power Lines Service Before YOU Begin Assembly Make sure that the power cord is unpluggedAgain. if the Connectors are not CON Sure that all of the holes are aligned see75 Ohm HOW to Connect a 75 OHM Catv Cable HOW to Connect AN External Source Using a Catv CableChest Pulse Sensor Care and Maintenance HOW to USE the Chest Pulse SensorHOW to PUT on the Chest Pulse Sensor Chest Pulse Sensor TroubleshootingPRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Features of the Console HOW to Turn on the Power HOW to USE the Manual ModePulse sensor. Next, stand on the foot rails Follow your progress with the displaysMeasure your heart rate if desired Contacts for about 15 secondsTurn on the fan if desired HOW to USE a Preset ProgramSelect a preset program Whenkey. you are finished exercising, removeIncline settings for the next segment Workout Intensity barTurn on the fans if desired HOW to USE a Distance ProgramSelect a Distance program Select a Custom program HOW to Create a Custom ProgramProgramsettings. the desired speed and incline HOW to USE a Custom Program Select a Pulse program HOW to USE a Pulse ProgramAdjust the maximum target heart rate setting if Desired Follow your progress with the displays Workout Intensity bar Press the On/Off button to turn on Television HOW to Operate the Personal TelevisionPress the Volume buttons to adjust the volume Press the Channel buttons to select Desired cable channelHOW to USE the Information Mode HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USETroubleshooting Problem The power turns off during useTop View Problem The walking belt slows when walked on Problem Television reception is poor Problem The chest pulse sensor does not function properlyWorkout Guidelines Conditioning GuidelinesExercise Intensity Exercise FrequencyR1207A Qty DescriptionOrdering Replacement Parts Exploded Exploded Drawing B-Model No. HRTL89406.2 R1207A Exploded Drawing C-Model No. HRTL89406.2 R1207A Exploded Drawing D-Model No. HRTL89406.2 R1207A Limited Warranty