ASSEMBLY
Place all parts of the stepper in a cleared area and remove the packing materials, Do not dispose of the packing materials until assembly is completed. Note: Some small parts may have been
Assembly requires only the included allen wrench.
1.Raise the Stabilizer Frame (23) and the Frame (29) until they meet. Refer to the inset drawing. Set the Stabilizer Frame into the saddle on the Frame. Attach the Stabilizer Frame to the Frame with an M8 Curve
Washer (2} and the Frame Knob (36).
2.While holding the Upright (27) near the Frame (29) as shown, connect the Reed Switch Wire (34) to the Upper Wire (37). Attach the Upright to the Frame with three M8 Curve Washers (2), three M8 Spring Washers (9), and three M8 x 15ram Screws (3).
23
36 2 29
2
34_
2
4