3.Insert one end of the Handlebar (24) into the bracket on the Frame (29). Center the Handlebar in the brack- et and rotate the Handlebar to a comfortable position. Secure the Handlebar with an M8 x 16mm Flat Washer (1) and the Adjustment Knob (11).
4.Apply a small amount of soapy water to the Handlebar (24). Slide a Foam Grip (21) onto each side of the Handlebar. Insert a Handlebar Endcap (20) into each end of the Handlebar.
5.The Console (25) requires one =AA" battery (not included). An alkaline battery is recommended. To install batteries, turn the console over, remove the bat- tery cover, and insert the battery into the battery clip
(not shown). Make sure that the negative end of the battery (marked
6.Connect the console wire to the Upper Wire (37). Slide the Console (25) onto the Upright Cap (26). Insert the excess wire into the Upright Cap.
11
"'29
Bracket
4
21
Battery
over
®sI
_Battery
625 Console
7.Make sure that all parts are properly tightened before you use the stepper, After assembly is completed, some extra parts may be left over. Place a mat under the stepper to protect the floor.
5