ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the two
included hex keys, assembly requires a phillips screwdriver , two adjustable
wrenches , a rubber mallet , and pliers .
Use the drawings below to identify the small parts used for assembly. The number in parenthesis below each drawing is the key number of the part, from the PART LIST on pages 24 and 25. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been
M4 x 16mm M4 x 16mm Round | M8 Split | M8 x 18mm |
|
|
| |||
Screw | Washer |
| M8 x 23mm | M8 x 25mm | ||||
Washer | ||||||||
|
| |||||||
|
|
|
| Washer | Washer | |||
|
|
|
|
|
| |||
M8 x 13mm Button | M8 x 16mm Button | M8 x 20mm Button | M8 x 25mm Patch | M8 x 25mm Button | ||||
Screw | Screw |
| Screw |
| Screw | Screw | ||
M8 x 47mm Button Screw |
| M8 x 65mm Button Screw | ||||||
|
|
| Union Set |
|
|
|
1.Orient the Front Stabilizer (3) as shown. Attach the Front Stabilizer to the Frame (1) with four M8 x 65mm Button Screws (95) and four M8 Split Washers (85).
Next, attach the Front Shield (38) to the Front Stabilizer (3) with two M4 x 16mm Round Head Screws (91).
Then, tighten the two Frame Cushions (106) into the underside of the Frame (1).
1 | 91 |
|
| 38 |
|
| 1 |
|
| 3 |
|
|
| 85 |
| 85 | 106 |
| 95 | |
|
| |
| 95 |
|
4