Reebok Fitness RBE09950 manual Top of the Frame, being careful not to pinch, Wire Harnesses

5.Attach a Pedal Assembly (39) to the Left Pedal Arm (9) with five M4 x 16mm Screws (89).

Attach the other Pedal Assembly (not shown) to the Right Pedal Arm (not shown) in the same way.

6. Remove the two Pivot Shafts (10) from the two Pivot

Arms (not shown). Next, identify a Union Set (86), and

remove the screw from the barrel. Apply a small

amount of grease to the outside of the barrel.

Slide an M8 x 18mm Washer (93), a Wheel Cap (53),

and a 30mm Spacer (87) onto the barrel of the Union

Set (86). While another person aligns the indicated

holes in the Left Pedal Assembly (39), a Pedal Arm

Wheel (52), and a Pivot Shaft (10), insert the barrel

through all of the holes. Then, slide another 30mm

Spacer (87) onto the barrel.

Next, slide an M8 x 18mm Washer (93) and a Wheel

Cap (53) onto the screw of the Union Set (86), and

tighten the screw into the barrel.

Attach the other Pivot Shaft (not shown) and the other

Pedal Arm Wheel (not shown) to the Right Pedal

Assembly (not shown) in the same way.

7. While another person holds the Upright (4) near the

5

39

9

89

89

6

	10	93	86
		87
	87	53
93		52	39
86
	53
Grease	Align
	these
	holes

Frame (1), connect the Upper Wire Harness (58) to the

Extension Wire Harness (59). Slide the Upright onto

the top of the Frame, being careful not to pinch the

Wire Harnesses.

Attach the Upright (4) to the Frame (1) with two M8 x

47mm Button Screws (110), an M8 x 25mm Button

Screw (100), and three M8 Split Washers (85).

7

4

1

Do not pinch the wire harnesses during this step.

85

110

85 100

58

59

6