NordicTrack NEL5095.0 user manual

2.Have another person hold the Upright (2) in the posi- tion shown.

Connect the Upper Wire Harness (30) to the Lower Wire Harness (42). Insert the connectors on the Wire Harnesses up into the Upright (2). Carefully pull the upper end of the Upper Wire Harness to remove the slack from the Wire Harnesses. See the inset drawing. Attach the Lower Wire Harness to the Upright with the Nylon Zip Tie (97). Pull the Nylon Zip Tie tight and cut off the excess.

Insert the Upright (2) into the Frame (1). Be careful to avoid pinching the Wire Harnesses (30, 42). Attach the Upright with two M10 x 108mm Button Screws (70), two M10 Split Washers (73), and two 7.6mm Spacers (47). Make sure that the curved sides of the

Spacers are facing the Upright. Be careful to avoid damaging the Wire Harnesses with the Button Screws. Do not tighten the Button Screws yet.

3.Slide a Weld Spacer (28) onto the axle on the left side of the Upright (2), with the open side of the Weld Spacer facing the Upright. Apply a small amount of the included grease to the axle.

Slide an Upper Body Arm (29) onto the axle on the left side of the Upright (2). Using the included Push Nut Tool (96), tap a Push Nut (31) onto the axle; make sure that the Push Nut is turned as shown in the inset drawing.

Attach the other Upper Body Arm (29) to the right side of the Upright (2) in the same way.

4.Look inside one of the Handlebar Cover Sets (26) and locate the square tabs connecting the two halves. Gently lift the tabs and disconnect the halves.

Hold the two halves of the Handlebar Cover Set (26) around the tube on the left side of the Upright (2). Align the halves and press them together until they lock. Attach the other Handlebar Cover Set (26) to the right side of the Upright (2) in the same way.

5

2				Pull
	2				2
70	73	47		30	97
				42
7347				1	142
3
					2
29				Grease
	96		31	28	Axle	29
31	Axle
4
				2		26
26