5.Lubricate an M10 x 165mm Bolt (18). Attach the Right and Left Backrest Frames (3, 4) to the for- ward tube in the Main Frame (1) with the Bolt, two M10 Washers (28), and an M10 Nylon Locknut (19).
Do not over tighten the Nylon Locknut; it must be easy to pivot the Backrest Frames.
Tighten the Screws (16) used in step 4. Tighten the Nylon Locknuts (19) used in steps 1Ð3.
6.Note that the brackets on the Backrest Frames (3, 4) have three sets of oval adjustment holes and one set of round holes.
Position the Spacer (25) between the brackets on the Backrest Frames (3, 4) and line it up with the round holes. Insert an M10 x 115mm Bolt (26) through the round holes in the brackets and through the Spacer. Secure the Bolt with an M10 Nylon Locknut (19). Note: The Spacer must be posi- tioned under the Main Frame (1).
7.Attach the Seat (7) to the brackets on the Main Frame (1) with four M8 x 16mm Screws (15).
6
5 |
|
|
19 | 28 |
|
| 4 | 28 |
| 3 | 18 |
|
| Lubricate |
|
| 1 |
6 |
|
|
|
| 4 |
|
| 1 |
| 19 | 3 |
|
| |
|
| 25 |
|
| 26 |
7 |
|
|
|
| 7 |
1 |
|
|
15 |
| 15 |
|
|