NordicTrack NTCCM58020 specification

INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR

If you purchase the optional chest pulse sensor (see page 15), follow the steps below to install the receiver included with the chest pulse sensor.

1.Look under the Console (4) and locate the left water bottle holder. Insert the tip of a flat-bladed screwdriver between the side of the water bottle holder and the Console in the location shown by arrow A. Gently pry the indicated tab out of the small slot in the side of the water bottle holder. Firmly push up on the bottom of the water bottle holder until the tab remains outside of the slot when the screwdriver is removed.

Next, insert the tip of the screwdriver between the opposite side of the water bottle holder and the Console

(4)in the location shown by arrow B. Gently pry the side of the water bottle holder away from the Console and push the water bottle holder out of the Console.

Remove the right water bottle holder in the same way.

Next, locate the round audio cable jack. If there is a sil- ver ring around the jack, remove the silver ring by turn- ing it counterclockwise with the screwdriver.

2.Remove the four recessed screws (not shown) from the underside of the Console (4). Do not remove the screws attaching the Console to the Upright (3).

Hold the fan and the top of the Console (4) in the loca- tions shown at the right. Carefully lift the fan and the top of the Console; do not let the fan slide out of the top of the Console.

3.While another person holds the top of the Console (4) and the fan in a vertical position, slide the receiver onto the indicated plastic pin on the Console; make sure that the receiver is oriented exactly as shown. Locate the two small screws included with the chest pulse sensor. Attach the receiver to the Console with the two screws as shown.

Connect the wire on the receiver to the indicated wire on the Console (4). Note: The other wires included with the chest pulse sensor may be discarded.

1
		Tab
		4
	B	A
	B
		Water
		Bottle
		Holder
	Jack
2		Hold and lift here
		Hold and lift here
		4
		3
3		4
		4
		Screws
		Receiver
		Pin
		Wire

4.Refer to step 2 above. Lower the top of the Console (4) and the fan. Make sure that no wires are pinched. Reattach the top of the Console with the four screws removed in step 2. Refer to step 1 above. Press the water bottle holders back into the Console. If you removed a silver ring from the audio cable jack, reattach the silver ring.