NordicTrack NTCCM58020 user manual Troubleshooting and Maintenance, HOW to Adjust the Reed Switch

Page 16

TROUBLESHOOTING AND MAINTENANCE

Inspect and tighten all parts of the stepper regularly. The stepper can be cleaned with a soft cloth and a small amount of mild, non-abrasive detergent. Keep liquids away from the console.

HOW TO ADJUST THE REED SWITCH

For the console to display correct feedback, the pedals must move at least five inches with each step. If the console displays incorrect feedback when the pedals are moved five inches or more, the Reed Switch (56) should be adjusted.

8

65

26

64

13

52

32

56

46

Turn the Flywheel (46) until the Magnet (32) is aligned with the Reed Switch (56) (refer to the inset drawing). Loosen the indicated Screw (52). Slide the Reed Switch slightly closer to the Flywheel, and retighten the Screw. Make sure that the Magnet will not hit the Reed Switch when the Flywheel turns. Repeat until the console displays correct feedback.

Carefully slide the Right Side Shield (8) back onto the stepper. Reattach the three M4 x 38mm Screws (64) and the two M4 x 25mm Screws (65). Reattach the Pedal Bracket (13).

HOW TO LEVEL THE STEPPER

Remove the right Pedal Bracket (13) by removing the two M10 x 82mm Button Bolts (26) and the two M10 Nylon Locknuts (not shown). Then, remove the two M4 x 38mm Screws (64) and the three M4 x 25mm Screws (65). Carefully slide the Right Side Shield (8) off the stepper.

If the stepper rocks slightly during use, turn one or both of the Feet (15) under the Stabilizer (2) until the stepper is level.

2

15

16

Image 16
Contents Model No. NTCCM58020 Serial No QUESTIONS?Customer HOT Line Table of Contents Important PrecautionsBefore YOU Begin FrontBack Left SideAssembly Page Handgrip Pulse Wire 70 or the Pulse Extension Damage the Wires as you insert the Button BoltsBe careful To avoid Pinching Wires During this step Console Screws 57. Make sure that the wires areInstalling the Receiver for the Optional Chest Pulse Sensor HOW to Operate the Stepper Features of the Console HOW to Exercise on the StepperHOW to USE the Manual Mode Begin stepping and change the stepping Speed as desiredLeft display Right displayTurn on the fan if desired HOW to USE Preset Workout Programs HOW to Connect Your Portable Stereo HOW to Connect Your Home Stereo HOW to Connect Your Computer Press the play button HOW to USE Programs Directly from OUR WEB Site Begin stepping to activate the console. See onFollow the on-line instructions to start Program Return to the stepper and begin steppingHOW to Adjust the Reed Switch Troubleshooting and MaintenanceHOW to Level the Stepper Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. NTCCM58020 Qty Description36 88 35 2318 HOW to Order Replacement Parts Limited Warranty