NordicTrack NTCCM58020 user manual Tube on the Upright be careful not to damage, Not pinched

5. While another person holds the Left Handlebar (6) near

the Upright (3), connect the Handgrip Pulse Wire (70)

to the Pulse Extension Wire (98). Insert the excess

wiring into the Left Handlebar.

Hold two Handlebar Bushings (66) around the rectan-

gular tube on the left side of the Upright (3). Slide the

Left Handlebar (6) onto the Handlebar Bushings and

the tube on the Upright; be careful not to damage the

the Handgrip Pulse Wire (70) or the Pulse Extension

5

66

70 28

5

3

Wire (98). Attach the Left Handlebar with two M8 x

35mm Button Bolts (24), two M8 Split Washers (54),

and two M8 Nylon Locknuts (28); be careful not to

damage the Wires as you insert the Button Bolts.

Firmly tighten the Nylon Locknuts.

Attach the Right Handlebar (5) in the same way.

6. While another person holds the Console (4) near the

6

98

54 24

Be careful

to avoid

pinching the

Wires (70,

98)during this step.

Upright (3), connect Extension Wire Harness (77), the

Pulse Extension Wire (98), and the ground wires to the

corresponding wires on the Console. Insert any slack

wire up into the Console and down into the Upright.

Attach the Console (4) to the Upright (3) with four

Console Screws (57). Make sure that the wires are

not pinched.

Snap the bookrack onto the Console (4) in the location

shown.

6	4
	Bookrack
	77
	98
	Console
	Wires
	Ground
	Wires
	3
57	Be careful to avoid
	pinching the wires

during this step.

7.Make sure that all parts of the stepper are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the stepper.

6