ParaBody GS4 manual Step

5/16 X 1” 38		AI
ALLEN SCREW	30
	AJ
	U	18
	33	10 3/8 X 2”
		J
		A
FIGURE 10		PLUNGER
		PIN

STEP 10:

•SECURELY assemble one SEAT/BACK PAD (AI) to the SEATADJUST (J) using two 3/8 X 2” BOLTS (10) and two 3/8” WASHERS (18).

•Assemble two ROLLER PADS (AJ) to the SEAT ADJUST (J) using one 3/4 X 18-1/8” TUBE (U), four PLASTIC WASHERS (33) two ROLLER PAD CAPS (30) and two 5/16 X 1” ALLEN SCREWS (38) as shown in FIGURE 10.

•CAREFULLY insert the SEAT ADJUST ASSEMBLY into the FRAME (A) as shown. The SEAT height can be adjusted using the

PLUNGERPIN.

		3/8 X 1-1/4” 12
	AI	W
38	5/16 X 1”	PLUNGER
	ALLEN SCREW
		PIN

1/2 X 5-3/4” 1	A
30
AJ	20
V
33

FIGURE 11

STEP11:

•SECURELY assemble one SEAT/BACK PAD (AI) to the BACK INCLINE ADJUST (W) using two 3/8 X 1-1/4” BOLTS (12).

•SECURELY assemble the BACK INCLINEADJUST (W) to the FRAME (A) using one 1/2 X 5-3/4” BOLT (1) and one 1/2” LOCK NUT (20). The BACK PAD angle can be adjusted using the PLUNGER. (Note: Tighten this connection enough to remove excess play yet allow the BACK INCLINEADJUST to rotate freely.)

•Assemble two ROLLER PADS (AJ) to the BACK INCLINE ADJUST (W) using one 3/4 X 20-3/8” TUBE (V), four PLASTIC WASHERS (33) two ROLLER PAD CAPS (30) and two 5/16 X 1” ALLEN SCREWS (38) as shown in FIGURE 11.

12