3/8 X 8” 3 | 18 | |
| |
| 25 | 35 |
| |
| X | 19 |
| |
6 3/8 X 3-3/4” | | AM |
| |
D | E | |
| |
24 | | |
| 35 | |
| 19 | |
FIGURE 15 | | |
STEP 15:
•Route the LAT CABLE (AM) through the PRESS ARM SUPPORT FRAME (X) and assemble one 3-1/2” PULLEY (35) to the FRAME PRESS ARM SUPPORT FRAME (X) using one 3/8 X 8” BOLT (3), two 3/8” WASHERS (18), two 3/8 X 1-1/4” SPACERS (25) and one 3/8” LOCK NUT (19). See FIGURE 15.
•Route the LAT CABLE (AM) around one 3-1/2” PULLEY (35) and assemble the PULLEY to the LEFT (D) and RIGHT (E) BOOM PLATES using one 3/8 X 3-3/4” BOLT (6), two 3/8 X 15/16” SPACERS (24) and one 3/8” LOCK NUT (19). See FIGURE 15. (NOTE:
Make sure the cable runs in the grooves of the pulleys.)
16
